![]() Do not remove the connector from the TPS for this test.ģ- Attach the positive lead of a voltmeter to this paper clip and the negative lead to a good ground.Ĥ- turn the ignition switch to the on position, do not start engine.ĥ- The voltage at the TPS center terminal should be 1.0 Volt (within. Caution: Before testing the TPS, verify that the engine is set at correct low idle speed.ġ- After Confirming the correct linkage adjustment and idle speed, proceed to the following.Ģ- Attach a Paper Clip into the center terminal of the TPS electrical connector.
0 Comments
Leave a Reply. |